nsahotels.blogg.se - Firstcom expresscard drivers

Select Finish when the InstallationShield Wizard has been completed.

Select Install to begin the driver installation.

Choose the destination folder for the driver and click Next to continue.

Select 'I accept the terms of the License agreement' and click Next to continue

Click Next to continue the InstallationShield Wizard.

Double click on the setup file (NECEL-USB3-Host-Driver-10200-setup.exe) to begin the installation.

Extract the ZIP file from the ZIP archive.

Download and store the USB 3.0 driver on your computer.

But I have read about conflicts with the WLAN-Driver (switching it off.

The first Firewire Express Card was a Firstcom Card (don't know the. Step 8: Align the contacts of the PCI/PCI Express card with the open slot on. If the Board ID is not 0, then the driver uses the “Board ID” to be the first COM port. 4 and insert the USB3.0 Express Card into the Express Card slot (the thinner end goes in first).

Remove the dummy card that is installed in your notebook's Express Card slot.

Press the slot opening on the left side your notebook (some notebooks have the slot opening on the right side of the notebook).

Give your Operating System a few minutes to recognize the new hardware before proceeding with the installation.

Connect the disk drive power connectors from the system power supply to the USB3.0 PCI-E Card.

Insert the USB3.0 PCI-E Card into the PCI-E slot.

Locate the PCI-E slot on the motherboard.

Files File Description File size Last modified USB 3.0 Driver Installation Guide 576 kB NECEL USB 3.0 Host Driver (10200) 6906 kB USB 3.0 PCIe Add-on Card Installation